18in Cycle Rim on Standing Rod with Gear Motor

1 views

Bounding box: 457.1 × 457.0 × 370.0 mm
Engine: Precision B-rep
Parameters: 23
Published: September 13, 2026

Download

Free to download and use. See the terms.

The prompt

Built 18in Cycle Rim on Standing Iron Rod (precision). the lower connected to rode to ring side the rode make small gap and this gap fix a gear motor to the lower shaft of ring the upper rode length make too rdule cole to 0

Parameters

Name	Value	Range
Rim Outer Diameter	457 mm	300 – 700
Rim Radial Thickness	22 mm	8 – 60
Rim Width	22 mm	8 – 60
Spoke Groove Width	8 mm	2 – 30
Spoke Groove Depth	8 mm	1 – 20
Hub Diameter	40 mm	15 – 120
Hub Height	70 mm	20 – 200
Spoke Count	32 count	6 – 48
Spoke Diameter	4 mm	2 – 12
Rod Diameter	16 mm	6 – 60
Lower Rod Length (below hub)	300 mm	60 – 900
Upper Rod Length	0 mm	0 – 300
Motor Gap in Rod	90 mm	40 – 250
Gearbox Width (X)	60 mm	30 – 160
Gearbox Depth (Y)	50 mm	30 – 160
Motor Can Diameter	44 mm	20 – 140
Motor Can Length	70 mm	20 – 200
Output Shaft Diameter	10 mm	4 – 40
Output Shaft Length	45 mm	15 – 150
Drive Gear Module	1.5 mm	0.5 – 5
Drive Gear Teeth	24 count	8 – 60
Drive Gear Face Width	10 mm	3 – 40
Drive Gear Bore	8 mm	2 – 40

Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.

More models

Browse the full gallery →

235.0 × 155.0 × 122.5 mmPrecision

Spur Gearbox

design gearbox

STEPSTLGLB16 PARAMS

28.0 × 28.0 × 10.0 mmPrecision

Spur Gear (12 Teeth)

Built a gear with 12 teeth

STEPSTLGLB5 PARAMS

84.0 × 84.0 × 15.0 mmPrecision

Involute Spur Gear with Keyway

Precision Involute Spur Gear with Hub and Keyway: Module (m) of 2.0 mm, 40 teeth (z), Pitch Circle Diameter (d) of 80.00 mm, 20° pressure angle (\alpha), 15.00 mm face width (b), a

STEPSTLGLB7 PARAMS